Anybody have any tips with printing the column with lanterns? I'm printing the pre-supported version and I'm getting curling where the support hits the lantern and then the support gets knocked over. I'm going to try slicing the part in half horizontally at the bottom of the lanterns, just wanted to know if anybody has any tips with this one, I have printed the entire rest of the indoor set and dungeon set with no issue.
I know that this is an aesthetic choice so there are no specific numbers for these but, in general, how many of each of the scenic riser sizes (1, 3 and 5) has everyone printed. I'm just looking for a general idea as to how many of these I should print.
Hello all
Do i need to use support when i am printing floor?
i have try to print some, and the support take very long time to remove :(
is there a easy fix :D
No, as per the print guide, you DO NOT need to use supports to print the floor hexes. Your printer will bridge the gap fine without supports. If it doesn’t, make sure your speed setting is set to at least 40 to 50. If you end up with a few loose or errant strands of PLA underneath the hex, that’s normal, just snip/pull them off.
What orientation is best to print these? The length of the table isn't to long to just count on the normal bridging to work?
Hi Jason, The table bridged fine in upright orientation during our test prints. Regards, Jay
Same. Like Kris, I added a brim.