No, as per the print guide, you DO NOT need to use supports to print the floor hexes. Your printer will bridge the gap fine without supports. If it doesn’t,
make sure your speed setting is set to at least 40 to 50. If you end up with a few loose or errant strands of PLA underneath the hex, that’s normal, just snip/pull them off.
No, as per the print guide, you DO NOT need to use supports to print the floor hexes. Your printer will bridge the gap fine without supports. If it doesn’t, make sure your speed setting is set to at least 40 to 50. If you end up with a few loose or errant strands of PLA underneath the hex, that’s normal, just snip/pull them off.