Printing Floor
Hello all
Do i need to use support when i am printing floor?
i have try to print some, and the support take very long time to remove :(
is there a easy fix :D
100 Views
top of page
3D Printing
Public·2 members
bottom of page
Hello all
Do i need to use support when i am printing floor?
i have try to print some, and the support take very long time to remove :(
is there a easy fix :D
No, as per the print guide, you DO NOT need to use supports to print the floor hexes. Your printer will bridge the gap fine without supports. If it doesn’t, make sure your speed setting is set to at least 40 to 50. If you end up with a few loose or errant strands of PLA underneath the hex, that’s normal, just snip/pull them off.